News/Tips

Midwest Tungsten Service publishes a newsletter for our customers on a quarterly basis. As a service to our internet visitors, selected Tips from the post below can be viewed in .pdf format as well. Thank you for viewing our recent news & tips.


Differences in Diffusion Pump Fluid

The diffusion pump is an essential piece of machinery in many vacuum metallizing operations. However, the type of fluid that […]

Leaks and Gas Loads

When designing, operating, or repairing a vacuum metallizing system, much attention is given to the removal of gases from the […]

Water Vapor Effects

Water Vapor and Vacuum Metallizing Effects Water vapor is a factor in all metallizing systems. The presence of water vapor […]

Contamination Prevention

WAX is a cause of adhesion failure on edges or corners. The wax comes from waxed paper used in packaging […]

Basecoats for Vacuum Metallizing

This TIP is a commentary on thermal-cured lacquers used for basecoating in vacuum metallizing. The role lacquers play in vacuum […]

Problems in Spraying / Air Make Up for Lacquers

Paint Sags May be caused by holding gun too close to part or using the wrong solvent. Keep gun 8 […]

The Spray Booth

Spraying of solvent-based coatings for vacuum metallizing presents a fire and explosion hazard. While we no longer lose as many […]

Q & A – Aluminum Evaporants

I’m doing shielding work. How can I deposit more aluminum? A: If you have enough room and power, you should […]

Simple Tests

This TIP contains a number of simple tests that you can perform at your desk without any special equipment. The […]

How Far to Pump Down

We are frequently asked what the best vacuum level is for metallizing. There are several factors that must be considered […]